Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateGate Company in Waco, TX
Gate Installation in Waco is mostly a matching job, not a blank-slate job. The city has a deep inventory of pre-1950 homes and commercial properties, many on pier-and-beam foundations, with original wrought-iron and early steel gates still in service, alongside a steady run of post-1960 ranch and tract homes whose builder-grade gates are reaching the end of their hinge-and-fastener life. Waco’s blackland clay, long 100°F summers, and violent spring storms all work on gate posts, and a gate that was square in spring can be leaning by August. We’re gate specialists, not generalists, and Gate Repair Waco has served Waco since 2018. Call (855) 638-3208 for a free estimate.
Why Waco Homes Are Different
The single biggest difference here is the ground. Waco sits on expansive blackland clay that swells when it’s wet and cracks when it dries, and that wet-dry cycle moves post footings under gates on pier-and-beam and slab properties alike. A gate that was hung true can drop out of alignment without anyone touching it, and the hinges take the load.
Layer the weather on top: months of 100°F days cook and dry out wood pickets and accelerate hinge corrosion, moderate winter freezes work on the same metal, and spring storms bring high wind and hail that bend frames and drive panels out of plane. Repair demand in Waco spikes twice a year, once after storm season and again after the ground goes from soaked to cracked.
Housing era decides what we’re looking at. Early-1900s bungalows and Victorians in older neighborhoods tend to have wrought-iron and wood picket gates where the repair is about matching heritage metalwork. Mid-century ranch homes carry original steel and chain-link gates. Newer west-side subdivisions are full of builder-grade aluminum gates whose posts are the weak point. We size the fix to the era, not to a template.
Styles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
Our Main Waco Services
Two calls come in more than any other in Waco: a gate that won’t open or close right, and an automated gate whose operator has quit. Both are named core services here, not add-ons.
Gate Repair in Waco
Most Waco gate repair work starts with the frame and the ground underneath it. Clay movement tilts posts, wind storms twist frames, and hinges seize after enough hot, dry summers. We diagnose the mechanical layer first, because a gate that drags is often a footing problem dressed up as a hinge problem. If your ornamental gate is original to a pre-1950 property, we look at what can be repaired and re-hung before we suggest replacing metal that’s been there for generations. We service Linear, Viking, Ghost Controls, and the rest of the brand range on the operator side once the gate itself moves freely. Call (855) 638-3208 for gate repair.
Electric Gate Repair in Waco
When an automated gate stops responding, the fault can sit in the motor, the control board, the safety sensors, or the access hardware – and guessing gets expensive fast. We work through that stack in order: power, then the board, then the operator, then the safety edges and keypad, so you pay for the part that actually failed. On Waco properties, storm-related power surges and corroded connections are common culprits, and clay heave that twists a gate can trip a sensor that was fine last month. From the motor to the keypad, that’s the coverage. Call (855) 638-3208 for electric gate repair.
Gate Installation in Waco
New gate work in Waco is shaped by what’s already there. On older properties, the job is usually matching an existing wrought-iron or early steel gate so the new one doesn’t look grafted on, while newer subdivisions call for builder-grade aluminum replacements that will survive clay movement better than the originals did. Either way, footing depth and hang matter more than the panel. We handle the full scope, from the motor to the keypad, under our Gate Installation work.
Automatic Gate Installation
Signs you need it
You’re replacing a manual gate, or an older operator has failed and the honest answer is that the gate and its hardware are at the end of their working life together.
What it costs in Waco
Automatic gate installation typically runs about $3,200 to $7,500 in Waco, depending on the gate type and the operator you choose; the written estimate sets the final price.
How we do it
We measure the opening and check the ground, set the posts and operator to the gate’s real weight and travel, wire the power and safety edges, then test the full cycle with you present before we call it done.
Driveway Gate Installation
Signs you need it
The old driveway gate is sagging past adjustment, the posts have heaved with the clay, or the driveway layout has changed and the gate no longer lines up with it.
What it costs in Waco
Driveway gate installation typically runs about $2,400 to $6,500 in Waco, with the swing or slide style and panel material driving most of the spread; prices are estimates and the written estimate is final.
How we do it
We lay out the opening against the driveway grade, dig and set the posts to proper footing depth, hang the gate for clearance and swing, then fit the hardware and check the latch side for a clean close.
What Gate Installation Costs in Waco
| Item | Typical range in Waco |
|---|---|
| Automatic gate installation | $3,200 – $7,500 |
| Driveway gate installation | $2,400 – $6,500 |
| Sliding gate installation | $3,500 – $8,000 |
Will a new gate survive Waco’s clay soil?
Yes, if the posts go to proper footing depth and the gate is hung with room for movement. Blackland clay shifts with every wet-dry cycle, so we set footings for the soil here rather than for a flat lot. Call (855) 638-3208 for a free estimate.
Do you handle the power run and the safety edges?
We do. A full installation covers the operator, the power run to it, and the safety edges and sensors that stop the gate on contact. That’s part of the same job, not a separate trade. Call (855) 638-3208 to get your gate measured and priced.
Brands We Service in Waco
We work on your brand, and the roster covers both residential and commercial systems: Linear and Viking on the residential side, Ghost Controls for DIY-installed operators we’re now repairing, and DoorKing for multi-unit community entrances. Parts for common operators are on hand, so most repairs turn around in a single visit. See our brands for the full list.
See the difference
Before
After
Before
After
Before
AfterPricing for Gate Company in Waco, TX
| Service | Typical range in Waco |
|---|---|
| Automatic gate installation | $3,200 – $7,500 |
| Driveway gate installation | $2,400 – $6,500 |
| Sliding gate installation | $3,500 – $8,000 |
| Manual gate repair | $150 – $450 |
| Hinge and post repair | $180 – $550 |
| Gate alignment and re-hang | $200 – $600 |
| Electric gate repair | $250 – $850 |
| Control board replacement | $300 – $900 |
| Operator motor repair | $350 – $1,100 |
| Safety sensor and access hardware repair | $180 – $600 |
What pushes price up in Waco is mostly the ground: a gate whose posts have heaved with the clay needs footing work before any hardware goes back on, and heritage wrought-iron repairs can mean custom-fabricated pieces. The price is quoted and agreed before any work starts, and the written estimate is the number you pay.
Neighborhoods We Serve in Waco
We cover the whole city, including the older neighborhoods where heritage metalwork is common and the newer subdivisions where builder-grade gates are failing at the posts. After a heavy spring storm or a dry August, posts in older areas can be found leaning or heaving with the clay, and we see both the original ornamental gates on the old estates and the failing builder-grade gates on the west side. Same-day service is often possible for repair calls; installation work is measured and scheduled. We answer 24/7, and fast dispatch runs from 7am to 7pm.
- Sanger-Heights
- The near-north side
- Downtown and the older core
- West-side subdivisions
Service Area – Cities Near Waco
Our Waco work reaches the surrounding communities, and the same clay, heat, and storm conditions follow us out there. If you’re just outside the city limits, we cover Woodway, TX, Hewitt, TX, Lorena, TX, and China Spring, TX. Tell us where the gate is when you call and we’ll confirm scheduling and give you a free estimate.
Serving Waco, TX – Our Local Coverage Area
We serve Waco and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs About Gate Company in Waco
For repair calls, same-day service is often possible, with fast dispatch from 7am to 7pm. We answer 24/7, and a call outside dispatch hours is booked into the next opening, Sunday through Friday. New installation is measured and scheduled. Call (855) 638-3208 for a free estimate.
Often yes, depending on the gate’s height, placement, and whether it’s in an HOA. Check with the city’s building department and your HOA before ordering materials. We’ll tell you what the job involves so you know what to ask about. Call (855) 638-3208 to talk it through.
We serve both. A single-family driveway gate and a multi-unit community entrance get the same technician roster, and DoorKing operators on commercial entrances are part of our regular work. Call (855) 638-3208 and we’ll schedule a free estimate.
Whether your gate is a heritage wrought-iron piece on a pre-1950 property or a builder-grade slider in a newer subdivision, the fix starts with an honest look at the ground and the hardware. Call (855) 638-3208 for a free estimate. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday.
What happens when you call
- 1A real person answersNo phone trees. Talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3A background-checked tech heads outLicensed & insured, typically within the hour.
- 4You approve before work beginsNothing starts until you say go.
What Waco Customers Say
"Photo eye was misaligned so the gate refused to close after dark. Ten minute fix. He also cleaned the lens and pointed out that the sprinkler head was spraying it every morning, which is why it kept happening."
- Bryce Pruitt"Solar panel on our remote gate wasn't keeping the battery up through the winter. He repositioned it, replaced the battery, and explained the math on why the old placement was never going to work."
- Megan Brooks"Three other companies in Waco either didn't pick up or wanted to schedule me for the following week. These guys had someone out the next morning."
- Javier Delgado